ARTITEQ Click Rail PRO End Cap (Qty 2)

ARTITEQ Click Rail PRO End Cap (Qty 2)

The ARTITEQ Click Rail Pro End Cap is designed to give your picture hanging rail a neat, professional finish by covering the exposed hollow ends of the aluminum rail. These caps are shaped in way to allow you to insert wires/cables from either end without removing them.

What’s included

ARTITEQ Click Rail Pro End Cap (Qty 2)
> wire not included

A) Install Brackets

Install Click Rail PRO brackets on the wall. The end of the rail should ideally stop about 5mm before it hits a side wall or the end of your run to leave enough space for the cap. The cap needs about 5mm of space.

B) Push to Fit

The end cap has a small plastic “plug” or insert on the back that matches the shape of the rail’s profile. Simply align this with the open end of the rail and push it firmly into place. No glue or screws are needed; it is held in by friction.

C) Ensure a Flush Look

Make sure the cap is pushed all the way in so that the outer lip of the cap sits flush against the cut edge of the metal. This hides any jagged edges from where the rail might have been cut with a hacksaw.